
Q-SERIES 8mm? Panel Mounting LED Indicator
Order Overview
STANDARD OPTIONS
The Q8 Series is available with a range of standard options, to specify your LED, simply choose one option from each column.
An example is shown below.
Q
SERIES
Q
8
MOUNTING
HOLE
8 = ?8mm
P
BEZEL
STYLE
P = Prominent
R = Recessed
F = Flush
8
TERMINALS
1 = Solder Lug/
Fastons
(2.8 x 0.8)
2 = Pins
3 = Wires
6 = Short body
Pins
7 = Short body
Wires
G
BEZEL FINISH
C = Bright Chrome
B = Black Chrome
G = Satin Grey
XX
TYPE OF
ILLUMINATION
XX = Fixed Light
KK = Flashing Light
(only up to 28VDC)
YY = Bi-colour
ZZ = Tri-colour
Y
LED COLOUR
R = Red
G = Green
Y = Yellow
B = Blue
W = White
SR = Super Bright Red
12
VOLTAGE
02 = 2VDC
06 = 6VDC
12 = 12VDC
12A = 12VAC/DC
24 = 24VDC
24A = 24VAC/DC
28 = 28VDC
E
SEALING
(Blank) = Unsealed
E = IP67
8 = Short body
Solder lug/
faston
Example Q8P8GXXY02E
?8mm, prominent bezel, short body solder
lug terminals, satin grey finish, fixed light,
yellow, 2volt DC LED, IP67 Panel Seal
SG = Super Bright Green
SY = Super Bright Yellow
SB = Super Bright Blue
SW = Super Bright White
RG = Red/Green
RY = Red/Yellow
GY = Green/Yellow
RYG = Red/Yellow/Green
28A = 28VAC/DC
110 = 110VAC
220 = 220VAC
? Gold Faston terminal denotes Anode (+), silver terminal denotes Cathode (-)
? Standard wire length is 200mm, 24AWG, red wire denotes Anode (+), black wire denotes Cathode (-)
for other wire lengths consult APEM
? For LEDs with alternate voltages consult APEM
? Bi-colour LEDs, by connecting the gold Faston (+) one colour is produced, by reversing the supply voltage another colour is
produced – Bi-colours are available up to 28VDC. [AC products not available]
? Take care when soldering to the Faston terminals
? Short body pins and wires are only available up to 28VDC
? Short body Fastons are only available without integral resistor (2VDC)
? The Tri-colour LED has red and green LEDs when both are connected yellow is produced
? Standard Tri-colour Faston terminals are two Anodes (+) and one Cathode (-)
? Tri-colour wires are one red (+) and one green (+) Anode and one black (-) Cathode
? Tri-colour pins are centre (–) cathode, shortest (+) anode pin green, longest (+) anode pin red
? Tri-colours are only available up to 28VAC/DC and use 2.0mm solder lug/fastons
? Maximum panel thickness 7mm
? For behind panel epoxy sealed options please consult Apem
? We recommend using Superbright LEDs for use at 220VAC
? For resistorless versions (02) please pay attention to the forward voltage
www.apem.com
6